Share your ENSLD Experience

@Isaac Rowell

Thanks for your helpful comments!!!

And,

I just found that PL has updated its 300-420 dump with 116q now.

Anyone kindly sharing the new version PL 300-420 dumps with 116q?

Thanks in advance!

Anyone got the most recent VCE, PDF or know where to find it?

Hello, can anyone tell me where i can find the most recent dumps for this exam? Tnx!

Someone pass the exam recently?

Any update?

Thanks Evelyn Great materials !

please layla is a fake person, this is a old dump , i failed with this dump today

evelyn and layla are all fake person selling old dump that are not valid

need some dumps

until they don’t update on the dstut don’t fall prey to these johns,emmas and evelyns

Hey guys is this the right page for ENSLD? I don’t see any dumps being posted here unlike ENCOR / ENARSI

Question: 1
Which solution allows overlay VNs to communicate with each other in an SD-WAN Architecture?
A. External fusion routers can be used to map VNs to VRFs and selectively route traffic between VRFs.
B. GRE tunneling can be configured between fabric edges to connect one VN to another.
C. SGTs can be used to permit traffic from one VN to another.
D. Route leaking can be used on the fabric border nodes to inject routes from one VN to another.
Answer: B
Question: 2
An engineer must design a VPN solution for a company that has multiple branches connecting to a
main
office. What are two advantages of using DMVPN instead of IPsec tunnels to accomplish this task?
(Choose
two.)
A. support for AES 256-bit encryption
B. greater scalability
C. support for anycast gateway
D. lower traffic overhead
E. dynamic spoke-to-spoke tunnels
Answer: BE
Question: 3
Which NETCONF operation creates filtering that is specific to the session notifications?
A.
B.
C.
D.
Questions & Answers PDF P-3
Answer: A
Question: 4
An enterprise customer has these requirements:
end-to-end QoS for the business-critical applications and VoIP services based on CoS marking.
flexibility to offer services such as IPv6 and multicast without any reliance on the service provider.
support for full-mesh connectivity at Layer 2.
Which WAN connectivity option meets these requirements?
A. VPWS
B. MPLS VPN
C. DMVPN
D. VPLS
Answer: D
Question: 5
What is a benefit of using VRRPv3 as compared to VRRPv2?
A. VRRPv3 supports IPv4 and IPv6
B. VRRPv3 supports authentication
C. VRRPv3 supports preemption
D. VRRPv3 supports stateful switchover
Answer: A
Question: 6
A customer is discussing QoS requirements with a network consultant. The customer has specified
that endtoend path verification is a requirement. Which QoS solution meets this requirement?
A. IntServ model with RSVP to support the traffic flows
B. DiffServ model with PHB to support the traffic flows
C. marking traffic at the access layer with DSCP to support the traffic flows
D. marking traffic at the access layer with CoS to support the traffic flows
Answer: A
Question: 7
Which nonproprietary mechanism can be used to automate rendezvous point distribution in a large
PIM
domain?
Questions & Answers PDF P-4
A. Embedded RP
B. BSR
C. Auto-RP
D. Static RP
Answer: B
Question: 8
Which QoS feature responds to network congestion by dropping lower priority packets?
A. CBWFQ
B. tail drop
C. WRED
D. strict priority
Answer: C
Question: 9
Which two BGP features will result in successful route exchanges between eBGP neighbors sharing
the same
AS number? (Choose two.)
A. advertise-best-external
B. bestpath as-path ignore
C. client-to-client reflection
D. as-override
E. allow-as-in
Answer: DE
Question: 10
A company is running BGP on a single router, which has two connections to the same ISP. Which BGP
feature ensures traffic is load balanced across the two links to the ISP?
A. Multihop
B. Multipath Load Sharing
C. Next-Hop Address Tracking
D. AS-Path Prepending
Answer: B

uestion: 5
What is a benefit of using VRRPv3 as compared to VRRPv2?
A. VRRPv3 supports IPv4 and IPv6
B. VRRPv3 supports authentication
C. VRRPv3 supports preemption
D. VRRPv3 supports stateful switchover
Answer: A
Question: 6
A customer is discussing QoS requirements with a network consultant. The customer has specified
that endtoend path verification is a requirement. Which QoS solution meets this requirement?
A. IntServ model with RSVP to support the traffic flows
B. DiffServ model with PHB to support the traffic flows
C. marking traffic at the access layer with DSCP to support the traffic flows
D. marking traffic at the access layer with CoS to support the traffic flows
Answer: A
Question: 7
Which nonproprietary mechanism can be used to automate rendezvous point distribution in a large
PIM
domain?
Questions & Answers PDF P-4
A. Embedded RP
B. BSR
C. Auto-RP
D. Static RP
Answer: B
Question: 8
Which QoS feature responds to network congestion by dropping lower priority packets?
A. CBWFQ
B. tail drop
C. WRED
D. strict priority
Answer: C
Question: 9
Which two BGP features will result in successful route exchanges between eBGP neighbors sharing
the same
AS number? (Choose two.)
A. advertise-best-external
B. bestpath as-path ignore
C. client-to-client reflection
D. as-override
E. allow-as-in
Answer: DE
Question: 10
A company is running BGP on a single router, which has two connections to the same ISP. Which BGP
feature ensures traffic is load balanced across the two links to the ISP?
A. Multihop
B. Multipath Loscad Sharing
C. Next-Hop Address Tracking
D. AS-Path Prepending
Answer: B

Do we not have any dumps for this exam?

Anyone got cbt nuggets videos for design?

amir and chapman are all spammer person, i failed with this dump yesterday

@Anonnymous -Kindly share the update PL dump , I don’t see this on the forum

many thanks and congrats on the exam

I passed ENSLD. The OCG and CBT Nuggets were enough. I also tried to search some dumps online, most of them are from the old CCDP. Be careful with that. There is plenty of free dumps about ENSLD online, but many of them have some questions answered incorrectly. Be careful with that too. Just do your best to answer those questions and go deep if you think that the answer should be different. ENSLD is not a very hard exam, but it took me 90 minutes to complete it because of some tricky questions. Do not spend a single coin in dumps. You do not need it. Spend some days looking for free dumps. But most importantly, make sure you are learning the material. Again, OCG and CBT Nuggets were all I needed to prepare. I wish you the very best.

Congratulations ENSLDxXx!!

Much thanks for your good tips and advice.

Congrats Fadil,

Can u share the dumps?

What do you think about these 2 questions:

Q
An engineer must design an in-band management solution for a customer with branch sites. The solution must allow
remote management of the branch sites using management protocols over an MPLS WAN. Queueing is implemented at
the remote sites using these classes:
How must the solution prioritize the management traffic over the WAN?

A. Mark the traffic with DSCP CS1 and map into Class2 with a minimum bandwidth assigned by reducing the bandwidth
available to CIass3.
B. Mark the traffic with DSCP CS6 and map into Class1 with a minimum bandwidth assigned by reducing the bandwidth
available to Class2
C. Mark the traffic with DSCP EF and map into Class1 with a minimum bandwidth assigned by reducing the bandwidth
available to Class2.
D. Mark the traffic with DSCP CS2 and map into Class2 with a minimum bandwidth assigned by reducing the bandwidth
available to Class3
Correct Answer: C

Q
Refer to the exhibit. A customer needs to apply QoS to the network management traffic passing through the GigabitEthernet0/2 interface. All eight queuing classes are in use, so the new requirement must be integrated into the existing policy. Which solution must the customer choose?

A. Mark traffic to DSCP CS5 and assign it to the SIGNALLING class. Then, baseline existing queue sizes to determine if additional bandwidth can be provisioned to the SIGNALLING class.
B. Mark the traffic to DSCP CS4 and assign it to the SIGNALLING class. Then, prioritize traffic within the class.
C. Mark the traffic to DSCP CS6 and assign it to the ROUTING class Then, prioritize traffic within the class.
D. Mark the traffic to DSCP CS2 and assign it to the ROUTING class Then, baseline existing queue sizes to determine if additional bandwidth can be provisioned to the ROUTING class

Answer: D

does anyone have a link to CBT Nuggets for this exam please? thanks in advance

Hi Guys.

Here Dumps.

Here dump, i did 980 points

https://drive.google.com/file/d/1Pq0ahIbHsDHmTivL3YFNJOejFkdMzFQl/view?usp=sharing

Mee too

Failed using all your paid dumps

any dumps, pdf, VCE available?

Hi Team,

Please confirm in ENSLD 300-420 exam, labs included? or only multiple choice questions?

Failed the exam today. Lot of new questions. Don’t rely on Florant’s dump. At least 10 – 20 new questions.

Failed the exam today. 10 – 20 new questions were not in dump at all.

Does anyone have the latest dump?

Hi all, I have passed with 953 since 30 minutes

ALL questions I faced came from dumps that I referred of Florant

Can anyone upload Florant´s dumps on a link?

Thanks!

to my knowledge there are many wrong answers in Florant dump

Don’t trust Florant’s dump. It is not reliable. There were at least 10-20 new questions not in the dump at all.

lhamdolah, i suceed in my exam today with Florant v1.2 dump (page3)

thanks to god, i passed the exam today with the same dump shared by Florant
Time spent on the exam : about 1 hour

Can anyone please upload florant´s dumps?

I think Florant is a fake man. I am searching for the new 300-420 dump. If anyone can help.

Passed. Very little questions came from florant dump.

Sunny,

Did you use the dump?

Madison, how many questions appeared in the exam from florant materials? Is it enough to pass it?

Hello all
I passed today my exam with a good mark (980/1000)
All the questions and drag & drop were from this dump.
qr.net/JyD6kN
You can rely to this dump to pass the exam with a good mark.
Good luck on the exam
Regards,

Hi everyone,
Passed since 30 minutes with excellente score 9X% in all topics, and i want to share with you my experience. Exam was easy but take time to read the questions.
Almost all the questions i found on the exam were on the dump shared by Chan.
Happy new year to everyone with the best wishes, and good luck in your exam.

Hey all,
I passed my exam this week with a good mark (980/1000)
All the questions and drag & drop were from this dump.
forms.gle/ukjvYgVvWtoHMyZb8
You can rely to this dump to pass the exam with a good mark.
Good luck on the exam
Regards,

I passed 2 days before with 96% There was few new questions

follow
????.??

Hi Cisco Community,
I just passed the exam but still waiting to get certified (awaiting for email confirmation).
Dump used : Chan dumps, 100% of the questions are there as well as drag and drops. for the courses, i used : Chris Bryant’s Udemy video course.
The exam was easy with the practice tests.
Next Juniper and fortinet exams,
Regards,

Hi all, I have passed my exam since few minutes, I am so happy that wanna share it with everyone.
For this exam, I used the practice test shared by Chan above, all the questions were there same in the exam. I highly recommand this practice test. For courses, i used udemy courses.
Next I will prepare for Juniper exam. I hope everything goes well.
good luck to everyone, I wish you all the best in your Cisco studies.
have a good day.

Hey all,
I passed the exam since 1 hour, all the questions i found on the exam are the same ones i found in the Chan dumps. I hope this helps somebody else like that other post helped me and my friend who passed too.
The best advice I got from on here is to use the dumps after finishing the courses (study guides that are directly covering all the topic). If you feel ready just schedule the exam and use the dumps.
Cheers

I passed the exam today too since few minutes, all the questions were the same ones i revised in Chan dump, i highly recommand it, happy to share with you that.